Device Side: Setting up voice over IP

If you navigate to your device user interface either by clicking in Control Studio on the device -> Modem Info and click on the settings cog or alternatively type in one of your modem IP addresses and add :8080 before hitting enter.

The log-in is always

username: admin

password: control

Go to Streams and Audio.

1. Set Mode to Broadcast.

2. Type in the radio IP address. It should be in most cases the default IP address 192.168.1.15, unless you are using data via Ethernet or have umbilical wired in your loom. For umbilical please make sure to use a unique IP address for each car and configure the x10i in the car accordingly to your settings via the MRTC app. In case you are using data via Ethernet, your x10i radio IP address needs to match your loggers network IP address/ Subnet. For more information please contact control support.

3. Type in the VPN IP address of the machine/server you use for using audio. Be aware that one vehicle can only send audio to one VPN at a time.

4. Use target port 9999 as default.

5. Click save and reboot streams.

Go to Device Config and Ethernet.

1. Set DHCP to Disabled

2. Give the TLM-P1 Evo a unique host IP address on the same network as the radio and if applicable the vehicle data logger. Be aware of which subnet mask is applied when choosing the IP address.

   So if using the default x10i car IP address of 192.168.1.15, use for example 192.168.1.200 as your vehicle network IP address of the TLM-P1 Evo and Vehicle Mask 255.255.255.0

3. Set the vehicle mask applicable to your network, for example to match your data loggers mask. If you do not use an Ethernet data logger, please use as default the mask 255.255.255.0.

In case you have umbilical wired in, the Garage IP address is the IP address of the TLM-P1 Evo on your garage network once umbilical is connected. So it needs to be a static IP address on your garage network, unique to each car outside of the DHCP range of your router.