TLM-P1 and TLM-P2 (without Update) - Firmware 1.3.x
Device User Interface - Page Functionalities
Logging in to device
In order to configure the device via the user interface you must first connect to the device. There are several options for this. USB Connection If yo...
Page: Telemetry - Set Data Destination
Log in to the device, see separate article in this section. Once logged in navigate to the Telemetry tab, followed by the TX Options menu on the left....
Page: Cellular Config - Selecting Cellular Networks
Log in to the device, see separate article in this section. With the Firmware Update 1.3.17 the Modem will get every 5 minutes automatic updates on th...
Page: IO - Setting RS232 Speed, CAN Speed and Addressing & Ethernet
Log in to the device, see separate article in this section. Navigate to the IO tab 1. If you have a telemetry stream using the RS232 interface, selec...
Page: System - Checking Connection and Telemetry State
Log in to the device, see separate article in this section. Once logged in navigate to the System tab Checking Connection State You will be able to se...
CAN
CAN Connection and Addressing
The TLM-Px modems support CAN using 11 bit addressing at 250Kb, 500Kb and 1Mb bus speeds. There is no terminating resistor inside the modem so the bus...
CAN Messages Transmitted from Device - DBC v1.7
A DBC file for the below messages can be obtained by contacting Control support or via Email at support@cntrl.io or via WhatsApp at +44 7723 366 365...
CAN Messages Received from Device- DBC v1.7
A DBC file for the below messages can be obtained by emailing support@cntrl.io TLM_Suppress_Transmit This message allows the logger to suppress the t...